Garden Pathway Lighting
Pathway Lighting – Garden path light is the choice of the landscape to the front and side and rear yard which creates a soft light source. Lighting will illuminate your way, highlight the gift plants, making Joe lighting recreational area in the open air, and prevents damage to sensitive plants that line the street. Choose the Garden Route lights including a rainbow of colors to choose from electrical power or solar. The lighting is available in different heights, W and installation options. Digging trenches 12 inches deep along the park lights. Put lighting fixtures along the way, spacing evenly fixtures. Located 12 cables placed along the trench to electrical outlets outside 10 meters from the first lighting fixture caliber in your Pathway Lighting. Turn off the power to the outlet. Make sure the power turned off using the non-contact circuit test. Install of transformer next to the outdoor outlet. De-half inch from the end of the 12-gauge wire on the party near the transformer. Loosen the final screws on the bottom of the adapter. Move the wire stripping under screw terminals.
Lighting fixtures stand upright. Check the distance and push the stock of Pathway Lighting fixtures in the ground to the base of the lighting fixture flush with the surface of the park. Repeat this process until all the lighting fixtures in place. Separate parts of the connector attached to the lighting fixture first. Move the connector at the top of the slide wire 12. Caliber pay connector halves together until you hear a click. Has been designing parts of the connectors specifically designed to penetrate the electrical wiring to make contact. Repeat this process until all the lighting fixtures connected to the power cord.
Install the adapter into an outlet outside. Check each light to ensure the flow of electricity. If the power is not there, unplug the adapter and the separation of conductors and return them in a separate area of the wire. Electrical tape wrapped around the wire where the first contact seeks to protect the integrity of the wire. Put the wire gauge 12 and connectors in the hole. Bury the cables and connectors. Enjoy this awesome article about Pathway Lighting.